Created Nov 16, 2007 by Larry Cochrane (Webtronics)
Below is a typical SaraAdSend.d configuration file. This file should be located in the \earthworm\run\params directory. The ModuleId must be added to the earthworm.d file also located in this directory.
# # CONFIGURATION FILE FOR SARAADSEND # ----------------------------- ModuleId MOD_SARAADSEND_A # Module id of this instance of SaraAdSend OutRing WAVE_RING # Transport ring to write waveforms to CommPort 1 # Comm port number PortSpeed 38400 # Comm port baud rate, can be set to 9600, 19200, 38400 or 57600 # # CHANNEL CONFIGURATION Nchan 3 # Specify number of channels to record, can 1 to 8 ChanRate 100 # Sampling rate in samples per second, can be 5, 10, 20, 50, 100 or 200 # # TIMING INFORMATION HeartbeatInt 15 # Heartbeat interval in seconds TimeoutNoSend 30 # Time in seconds before program will reset if no data from ADC board TimeoutNoSynch 60 # Not used UpdateSysClock 0 # 1 = PC time updated with AD board time HighToLowPPS 0 # 1 = PPS signal direction is High to Low TimeOffset 0 # Time Reference offset in milliseconds # # Time Reference Types: # 0 = Use PC Time, 1 = Garmin GPS 16 or 18, 2 = Motorola ONCORE NMEA, # 3 = Motorola ONCORE Binary, 4 = WWV (must have WWV option on the ADC board ) # TimeRefType 0 # One of the types above TimeFilePath c:\earthworm\ # where to place the time.dat file # # # OTHER INFORMATION LogMessages 1 # 1 = Log messages from DLL & ADC to log file NoPPSLedStatus 0 # 1 = Disable 1PPS LED blinking AdcDataSize 2 # ADC trace buffer data size in bytes. Can be 2 or 4 bytes # # # SCNL (Station/Component/Network/Location) FOR EACH ADC CHANNEL # Chan lines must follow the Channel Configuration lines in this file. There should # be Nchan (see above) SCNL lines. # # Chan Station/Comp/Network/Location # ------- -------------- Chan 0 STA BHZ PN NC Chan 1 STA BHN PN NC Chan 2 STA BHE PN NC #----------------------------- #